Status Message Control for Robot/SAVE

Before You Begin

Robot/SAVE writes a save status message for each operation it performs. These messages display on the Status and Completion Inquiry panel. For some status messages, you can override the setting that specifies whether the messages display a Warning fl ag on the Status and Completion Inquiry panel. The Warning flag indicates that there are warning messages for the backup. If you use Robot/NETWORK with Robot/SAVE, you also can specify the severity code that is sent to the Robot/NETWORK Status Center for those messages.

Overriding Status Messages

To specify the status messages that will display a Warning fl ag on the Status and Completion Inquiry panel, do the following:

1. Call the program RBS960 using the following command:

CALL RBS960

2. The Message Override Selection panel displays. The panel lists any message IDs that have been defined to issue a warning message. (Note: If no messages have been defi ned, the panel will be blank.)

Press function key 6 to add a message to the panel. (To change an existing message, enter a 1 next to the message you want to change. To delete a message from the list, enter a 4 next to the message.)



3. The Override Message Finder panel displays. Enter a 1 next to the message you want to add to the list. Only messages that appear on the Override Message Finder panel can be changed.



4. The Override Message Severity Maintenance panel displays. Enter a W in the Robot/SAVE message severity fi eld to have the message display a warning flag on the Status and Completion Inquiry panel. You also can specify the severity of the status that is sent to the Robot/NETWORK Status Center.



5. Continue to follow these steps to add as many messages as you wish to the Message Override Selection panel.

Updated Jan. 16, 2006