Determining Which Report/Set will Process a Specific Spool File

Quite often, it is necessary to set up a spool file in more than one Report/Set. Each spool file should have different spool file comparisons to identify them properly, but occasionally they change, or are not set up correctly. To verify which Report/Set will process a spool file, use the command REPDTMSET.

To use the REPDTMSET command:

1. Add RBTREPLIB to your library list, as follows:

ADDLIBLE RBTREPLIB

2. Enter the following command and press function key 4 to prompt it:

REPDTMSET

3. The Determine Search Set (REPDTMSET) panel displays.



4. Enter the name of the output queue where the report to be tested resides and press Enter. A list of the entries in that output queue displays.



5. Enter a 1 beside the report to be tested. The name of the Robot/REPORTS Report Set and Report Name that will process this spool file will display. If the Report Set and Report Name are *NONE, the report is either not set up, or is set up improperly.

Updated April 12, 2001